Re: Frame --> WinHelp conversion (#126906)

Subject: Re: Frame --> WinHelp conversion (#126906)
From: Bill Burns <wburns -at- MICRON -dot- COM>
Date: Wed, 21 Aug 1996 12:06:00 MDT

21-AUG-1996 11:11:06.78


>I tried to save Frame 4 files to .rtf and import to Word 6 and it was
>genuinely messy. Text on the master pages was intermingled throughout.
>I haven't tried the same maneuver with Frame 5 and Word 7, so I dunno.
>I'm guessing it can be done--but not without tinkering with the source
>a bit beforehand.

I recently imported some Frame 4 files to .rtf using Frame 5. I then
opened the files with Word 6.0. The only problem I had was with some
of the text formatting. Other than that, it went off without a hitch.

Bill Burns
Assembly Training and Documentation Supervisor
WBURNS -at- MICRON -dot- COM

TECHWR-L List Information
To send a message about technical communication to 2500+ list readers,
E-mail to TECHWR-L -at- LISTSERV -dot- OKSTATE -dot- EDU -dot- Send administrative commands
ALL other questions or problems concerning the list
should go to the listowner, Eric Ray, at ejray -at- ionet -dot- net -dot-



Previous by Author: Re: Personal Attacks and ???'s (#121687)
Next by Author: Re: SGML to MS Word Conversion (#312845)
Previous by Thread: Re: Moderated Techwr-l List?
Next by Thread: Contractor vs. Captive


What this post helpful? Share it with friends and colleagues:

Sponsored Ads


Sponsored Ads