Re: Corel Draw

Subject: Re: Corel Draw
From: "Michael A. Lewis" <lewism -at- BRANDLE -dot- COM -dot- AU>
Date: Fri, 24 Oct 1997 09:41:57 +1000

Damien Braniff wrote:
>
> I've (on and off) had a funny with Corel and wondered if anyone knew the
> cause/solution. Inserting an object into Word, create the drawing, update
> and close. The drawing is fine but the text is "funny" - not scaled,
> overruns boxes etc. Any ideas?

I've seen precisely this problem, even using Word Draw, with one
important exception: it's only screwed up on-screen -- printing is fine.
In your position, I would start asking questions about fonts and printer
drivers.
--
Michael Lewis
Brandle Pty Limited, Sydney, Australia
: PO Box 1249 : Suite 8, The Watertower :
: Strawberry Hills, NSW 2012 : 1 Marian St, Redfern 2016 :
: Tel +61-2-9310-2224 : Fax +61-2-9310-5056 :

Posts: mailto:techwr-l -at- listserv -dot- okstate -dot- edu
Commands: mailto:listserv -at- listserv -dot- okstate -dot- edu (e.g. SIGNOFF TECHWR-L)
Archives: http://listserv.okstate.edu/archives/techwr-l.html,
http://www.documentation.com/, or http://www.dejanews.com/
Subjects: JOB:, QUESTION:, SUMMARY:, ANNOUNCE:, or none of these.



Previous by Author: Re: Single Source Docs
Next by Author: Re: QUESTION: Using Information Modules
Previous by Thread: Corel Draw
Next by Thread: How much to charge to handling printing?


What this post helpful? Share it with friends and colleagues:


Sponsored Ads