Re: MS Word: force blank pages between sections
Greetings, Word Mavens: Scenario: TofC starts on an odd page. Because of pg numbering, I put a section break at the end of the ToC. I want Chapter 1 to begin on an odd page.
So I make the section break and "odd page" one. Sure enough, Chapter 1 start on an odd page, but the TofC is only one page long and Word does not insert a blank page on its back.
What do I do to get Word to dynamically create an even (blank, with headers and footers) page between two sections when the first one ends on an odd page?
An obvious solution is to create the extra page by hand (ie with a page break), but then what if the doc grows & the TofC becomes two pages ... ? Then I'll have to go back and dekludge.
When setting up your headers and footers for any section, make sure that the section contains three pages, even if some of them are blank. When you have created the three sets of headers and footers, you can delete the blank pages.
Winnipeg, MB R3G 2J3
- RE: MS Word: force blank pages between sections, Lisa Wright
MS Word: force blank pages between sections: From: John Cornellier
Previous by Author:
Re: It shouldn't be that hard to write good doc, should it?
Next by Author: Re: MS Word: force blank pages between sections
Previous by Thread: Re: MS Word: force blank pages between sections
Next by Thread: RE: MS Word: force blank pages between sections
Search our Technical Writing Archives & Magazine